5
1. TO GET READY IN FOUR STEPS
To get started with the Mobeye
®
only four steps are needed.
1. Place the SIM card in the Mobeye
®
.
Make sure this SIM card is not secured by a PIN code.
2. Place the four batteries.
3. Enter at least one phone number in the Mobeye
®
.
4. Check the settings
In this chapter these steps are explained.
1.1 STEP 1: SIM CARD
To use the Mobeye
®
a SIM card of any provider is needed. On this SIM card, the PIN code security
needs to be disabled. If you have a SIM card with PIN code, you can disable this using any mobile
phone and switch off the PIN code security. Please consult the manual of the used mobile phone for
the procedure.
The SIM card needs to be placed before the batteries. When using a prepaid SIM card, take care of
the remaining value. Apart from that it is wise to set a recurrent test message in the menu so the card
will be used at least once a month.
Open the back cover of the Mobeye
®
Place the SIM card in the holder. For opening/closing, shift the cover slightly.
1.2 STEP 2: PLACE THE BATTERIES
Place the four lithium 3,0 volt batteries (CR123). When replacing the batteries, all settings remain
unchanged.
After placing the SIM card and the batteries, the Mobeye
®
will perform a self test during 1 minute.
During the test, the light is red.
In case the light is flashing red, a problem with the SIM card is detected. A reason could be no SIM
card was placed, or the PIN code security of the SIM card was not disabled.
Close the Mobeye
®
using the 4 screws.
1.3 STEP 3: PROGRAM THE PHONE NUMBERS
You need to program at least one phone number in the unit. This phone number is used to send the
messages to.
Enter your 4 digit user code (factory setting: “1111”)
Press “menu”
Enter “01” (01 for the 1st phone number, 02 for the 2nd phone number)
Press “OK”
Enter the phone number (e.g. 0612345678)
Press “OK”
The light turns green and a confirmation melody is played.
The Mobeye
®
is ready to use.
1.4 STEP 4: CHECK THE SETTINGS
The settings can be sent to the set telephone number as SMS text message. In this way you also
check the correct working of the SIM card.
Enter your 4 digit user code (factory setting: “1111”)
Press “menu”
Enter “10”
Press “OK”
Within ca. 30 seconds the set phone number will receive the list with settings.
(6 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais